I need help programming my remote to work with the DTA. My old remote started to fail (number buttons failed to respond) so I bought a replacement. However, I cannot get it to pair with the DTA. I read that this was an issue, but I cannot figure out what people did to get it to work. The directions in the instructions don't seem to work.
DTA = Cisco DTA 271HD
Remote = HDA-RF2.2
Any help would be appriciated.
Solved! Go to Solution.
you should of gotten it from Spectrum.... You need to reset the DTA by unplugging it for 5 minutes then power it back up. or have Spectrum reset it.
Then, AIM THE REMOTE AT THE FRONT OF THE DTA...
Using your Adapter’s remote, press and hold the PROG buttonuntil the LED on the remote turns on, then press the INFObutton.